Protein Estimation by Bradford's Method Lab Report

Protein Estimation by Bradfords Method - Lab Report ExampleThis paper applies the Bradfords method to check out the family between protein concentration and absorbance rate. The study is based on launch assumption that observed rate of absorption is proportionate to protein concentration and developed relationship between known concentrations and observed absorbance rates can be used to determine unknown concentrations, given their absorbance rates. The studys data identifies a aberrance from the proposed proportionality between concentration and absorbance rates. Significance of this inconsistency is ascertained by analysis of variance that adopts the null hypothesis for lack of significant relationship between concentration and absorbance rates. This is because of the high probability value, 0.056 percent. Application of the proposed regression model confirms the inconsistency by yielding a negative concentration. The paper therefore concludes that the inconsistency with estab lished literature is because of inaccurate experimental results. Protein estimation by Bradfords method Introduction Proteins are essential components of cells and organs, a factor that forms the basis of their significance in the form as well as the need for their intake in nutrients to meet required levels for a healthy body. Nutritional needs institute the sizeableness of developed knowledge of required protein intake levels, and determination recommended quantities of food supplies that can meet such required levels. Existence of protein in definite concentrations in body fluids also identifies the significance of studying protein concentration in the body, which can be used to determine normalcy or cosmos diseases to alter equilibrium protein concentrations (Chem, p. 105). there are a number of techniques, such as the Bradford method, which can be used to determine protein concentrations in compounds. The method applies spectroscopy to relate known concentrations to their tally absorbance rate. This is because of a analogue relationship between concentration of protein in a solution and the ability of that solution to absorb dye (Maud and Foster, p. 164). Visibility of the absorbed dye, which is proportional to the dyes concentration in the solution, is therefore used to establish a relationship between absorbance readings from the spectroscopy and protein concentration (Ruf, p. 1). The Bradfords method push assumes that protein concentration is the only determinant of the dyes absorbance. This means that for any given environmental conditions, similar protein concentrations yield similar absorbance rates (Thermo, p. 1). A linear regression model can therefore be developed and used to determine unknown concentrations, given their identical absorption alues. The regression model determines existence of a significant relationship between the known concentrations and the absorbance rates for predictions, and regression coefficient (Ross, p. 131- 134). This study was performed to ascertain existence of a relationship between known protein concentrations and their corresponding absorbance rates. The study aimed at using the established relationship to determine unknown protein concentration, based on its absorbance rate. In order to achieve its objective, the study explored the question, is there a significant relationship between protein concentration and absorbance? The study investigated the following set of hypotheses for the research question. H0 There is no significant